
Kindly Reminder
Can't Find Your Required Components?
If your specific control system parts are not listed on our website, contact us immediately.
Our procurement specialists will source genuine new components tailored to your technical requirements.
All Amikon-supplied automation parts include:
12 Months Warranty
24h /7 online Service ( info@amikon.cn | +86 18020776786 )
Original new Factory Sealed
Kindly Reminder
Can't Find Your Required Components?
If your specific control system parts are not listed on our website, contact us immediately.
Our procurement specialists will source genuine new components tailored to your technical requirements.
All Amikon-supplied automation parts include:
12 Months Warranty
24h /7 online Service ( info@amikon.cn | +86 18020776786 )
Original new Factory Sealed
INTEGRATED AXIS MODULE
INTEGRATED AXIS MODULE
KINETIX 6000
360 / 480 VAC
6 KW / 9 AMP CONVERTER
3.9 KW / 8.6 AMP INVERTER
WITH SAFE TORQUE-OFF FEATURE.
INTEGRATED AXIS MODULE
INTEGRATED AXIS MODULE
KINETIX 6000
360 / 480 VAC
28 KW / 42 AMP CONVERTER
13.5 KW / 30 AMP INVERTER
WITH SAFE TORQUE-OFF FEATURE
DIRECT REPLACEMENT FOR 2094-BC04-M03
REPLACED BY 2198-D057-ERS3
VPL Low Inertia Motors
SERVO MOTOR
KINETIX LOW INERTIA
400V
100 MM
1 MAGNET STACK
6000 RPM
18-BIT ABSOLUTE MULTI-TURN DIGITAL ENCODER
(HIPERFACE DSL ENCODER)
SHAFT KEY
SINGLE SPEEDTEC DIN CONNECTOR
NO BRAKE
IEC METRIC
FREE MOUNTING HOLES (TYPE FF)
STANDARD
AXIS MODULE
AXIS MODULE
KINETIX 6200 / 6500
360 / 480 VAC
3.9 KW / 8.6 AMP INVERTER
WITH SAFE TORQUE-OFF FEATURE
AC frequency converter
PowerFlex 753 AC Drive
with Embedded I/O
Standard Protection
Forced Air, AC Input with DC Terminals
Flange Type, 22 Amps, 11kW ND
7.5kW HD, 400 VAC, 3 PH, Frame 2
Filtered, CM jumper installed (preferred)
DB Transistor, Blank (No HIM)
Kinetix 300 Servo Drive
120 Volts Doubler Mode:Yes
Continuous Output Current (0-peak):5.7 Amperes
Integrated AC (EMC) Line Filter:No
Input Voltage:120/240 Volts (AC), 1 Phase
Power Rating:800 W
Part Number/Catalog No.:2097-V31PR2-LM
Safe Torque-Off:Yes
Stratix 5700 managed Ethernet switch
Part Number:1783-BMS06SL
Product type:Managed Ethernet switch
Ports:6
Copper ports:4
Fiber ports:2
Input voltage:12 to 48 Volts DC
Operating temperature:-40 to 60 degrees Celsius
CONTROL MODULE
4139145401S1FX
CONTROL MODULE
SMC-FLEX
STANDARD
120-240 VAC
FLEX QUICK START
150-FS1FX
Controller drive
Nominal Bus Output Voltage 300V DC
Continuous Current(RMS) 45.0 A
Peak Current(RMS) 90.0 A
Continuous Power Output 15.0 kW
Peak Power Output 30.0 kW
Input Circuit Breaker Rating 38A RMS
Circuit Breaker Interrupt Rating 1300 A
Static Gain 1.5x Rated Motor I/RPM
POWER SUPPLY
POWER SUPPLY
INPUT: 100-240 V AC / 50/60 HZ / 23 AMP
OUTPUT: 56 V DC / 26.8 AMP
1500.8 WATT OUTPUT POWER
Servo Motor
SERVO MOTOR
KINETIX
LOW INERTIA
400V
130 MM
152.4 MM MAGNET STACK LENGTH
3000 RPM
1024 SIN/COS
SHAFT KEY
NO SHAFT SEAL
CIRCULAR (SPEEDTEC) DIN CONNECTOR
NO BRAKE
Servo Motor
SERVO MOTOR
KINETIX
LOW INERTIA
400V
100 MM
50.8 MM MAGNET STACK LENGTH
5000 RPM
1024 SIN/COS
SHAFT KEY
NO SHAFT SEAL
CIRCULAR (SPEEDTEC) DIN CONNECTOR
NO BRAKE
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.